Audiovox PCR2500 - Manual (Page 5)

PCR2500
5
OPERATING INSTRUCTIONS
On-Off Switch/Volume
Control
Rotate the ON/VOL knob (1) to the right to turn
the unit on. Continue rotation until desired
volume level is obtained
AM/FM Band Selector
Press the AM/FM button (2) to change the radio
band from AM to FM. FM broadcasts will be
received with the switch in the in
position,
and AM broadcasts will be received with the
switch in the out position.
Manual Tuning Control
Rotate the TUNING knob (3) to the left or right
to select the desired radio station. When tuning
in a station, always adjust the control so that
you are receiving the full signal and are on the
center of the broadcast frequency. If the radio is
not on
frequency, you could experience noise
and reception problems. The dial pointer will
move along the dial to indicate the frequency to
which you are tuned.
FM Local/Distant Selector
This selector switch is incorporated to allow
maximum reception in both weak and strong
“FM” signal areas. For normal reception
conditions and when receiving a wide range of
signals including weak or distant stations, the
switch should be set to the in position (DX),
which will allow maximum signal to the receiver.
When in an extremely strong (local) signal area,
set the switch to the Local (LOC) setting (out
position). This will eliminate weak signals and
suppress overly strong signals so as to avoid
overloading the receiver input. When moving
out of the strong signal area, return the switch
to the DX setting (in position).
NOTE: The local/distant selector only
affects “FM” signals, and will have no effect
on “AM” reception.
Cassette Door
Hold the cassette with the exposed tape edge
to the right and insert it into the cassette door.
Depress fully until the cassette is engaged and
begins playing.
NOTE: Observe the cassette operation
cautions in the Care and Maintenance
section of this manual.
1
2
3
4
5
ON/VOL TUNING
AM / FM / CASSETTE
FM 88 94 98 103 106 108 MHz
AM 54 60 70 80 100 130 170 x10KHz
DX
LOC
PCR2500
FF
3 2 1 4 5