Panasonic ES8243 - Manual (Page 5)

5
English
Cleaning
Clean
We recommend that you clean
your shaver with the “sonic”
vibration turbo-cleaning mode
when the faucet symbol
appears on the LCD panel.
1. Disconnect the power cord
from the shaver.
2. Apply some hand soap and
some water to the outer foil.
3. Press the OFF/ON switch for
more than 2 seconds to
activate the turbo mode for
“sonic” vibration cleaning.
appears on the LCD
panel.
After about 20 seconds, it
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.
4. Remove the system outer foil
and press the OFF/ON switch
for more than 2 seconds to
activate the turbo mode for
“sonic” vibration cleaning and
clean it with running water.
5. Wipe off any drops of water
with a dry cloth.
6. Remove the system outer foil
to allow it to dry completely.
•
•
Caution for turbo mode
Shaving in turbo mode may damage your skin. Turn the shaver
off and then on again to cancel turbo mode.
Do not place your fingers on the OFF/ON switch while using
the shaver. This may cause the shaver to turn off or enter turbo
mode. Place your fingers on the finger rest while using the
shaver. •
•
Lubrication
To maintain shaving comfort for a long time, it is recommended
that the oil provided with the shaver is used.
1. Switch off the shaver.
2. Apply one drop of oil to each of the outer foils.
3. Raise the trimmer and apply a drop of oil.
4. Switch the shaver on, and run it for approximately five
seconds.
5. Switch off the shaver, and wipe off any excess oil from the
outer foils with a soft cloth.
ES8243_EU.indb 5 2009/02/16 11:18:10