Scarlett SC-130S - Manual (Page 5)

www.scarlett-europe.com SC-130S 5
· Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, is hot and there is no water. Do not refill it with water
until the steam iron has cooled down.
BURST OF STEAM
· The burst of steam feature provides additional steam for removing stubborn wrinkles.
· Turn the temperature control dial to the or position.
· Turn the variable steam control to the maximum position.
· Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button pressed for more than
5 seconds.
VERTICAL STEAM
· Ensure that there is enough water in the water tank.
· Stand the steam iron on its heel rest on an iron-safe surface and plug it.
· Set the temperature control dial and variable steam control to their maximum positions.
· Hold the iron vertically and press the steam burst button, an intense steam will be ejected from the soleplate.
WHEN YOU FINISHED IRONING
· Set the temperature dial to the minimum position.
· Remove the mains plug from the wall socket.
· Stand the iron on heel rest.
CARE AND CLEANING
·
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.
· Do not use abrasive cleaners.
SELF-CLEANING
· Fill water reservoir up to the maximum level and then close it.
· Set the temperature control to its maximum position.
· Insert the main plug into the wall socket.
· Allow the iron to heat up until the indicator light goes out.
· Holding the iron horizontally over the sink, change the steam control to the self-cleaning position.
· Boiling water and steam will be ejected from the holes in soleplate with Impurities washed out. Rock the iron
forwards and backwards during this operation.
· Repeat self-cleaning if you notice that much impurity has been washed out.
· Move the iron over an old (preferably) piece of cloth. This to ensure that the soleplate will be dry during
storage.
STORAGE
·
Unplug the appliance from the power supply, empty the water tank (do it after each use) and allow steam iron
cool down completely.
· Wrap the cord around the heel rest.
· To protect the soleplate, place the steam iron in an upright position on its heel rest.
RUS
·
. ,
.
· ,
, , .
· . .
· .
· .
· , .
· , .
· , ,
.
· , ,
, .
,
.
·
.
· , .
· .
.
: ,
.