Panasonic EH2424 - Manual (Page 7)

7

• Adjust the nozzle while taking care not to
directly touch the steam.
How to use the steam
I Move your face slightly to the left and right so
that the steam spreads evenly.
I Using the steam on your nose is effective on
the T-zone.
1. Keep your face at least 25 cm away from
the steam outlet, using the supplied 25-cm
measure as a guide. (Fig. 5)
2. Position the steam outlet towards your face
slightly above your chin. (Fig. 6)
3. After use, wipe off the water (such as
with a tissue), then also apply a lotion to
prepare your face and apply an emulsion to
supplement skin oil.
Examples of the uses of
the facial ionic steamer
In addition to using the appliance on bare skin,
it can also be used in combination with facial
treatments.
I Before cleansing
1. Use the appliance for about 3 minutes.
(This lifts dirt from the skin.)
2. Perform cleansing.
I Apply massaging cream and use the steam
while massaging your skin.
I Use the appliance after applying lotions and
face liquids.
After use
(Be sure to discard the water in the tank every
time after use.)
1. Press the power switch until a click is heard to
turn off the power and then remove the plug
from the power outlet.
• The lamp turns off.
• Be careful not to touch the steam when
pressing the switch.
• Do not operate the appliance if it contains
no water.
- Doing so will quicken the accumulation
of water scale, which may result in poor
steam discharge.
2. Leave the appliance alone to cool for at least
10 minutes.
3. Discard the water in the drain cup.
4. Pour out the water from the appliance in the
direction of the arrow as shown.
• Emptying the water in a direction other than
that indicated by the arrow may get the
switch wet, which may cause a malfunction.
• To prevent risk of burns or scalding when
discarding the water, hold the bottom of the
appliance. (Fig. 7)
Note: When discarding the water, be careful not
to get water on the power plug and cord.
5. Wipe off any water from the appliance.
• Do not wind the cord around the appliance.
• If the water supply cup is to be placed
upside down on the appliance for storage,
first wipe off any water from the cup.
Cleaning
Do not wash or soak the appliance in water.
Cleaning around the water inlet and water
level. (Clean once a month)
I To remove and prevent water scale deposits,
let the appliance cool for at least 10 minutes
after use and then clean according to the
following steps.
After the operation in step 4 on “After use” of
the Instruction Manual, replace the drain cup
into the appliance.
1. Open the water supply cover and add water
using the water supply cup.
• Add water until the “full” mark on the
appliance.
2. Close the water supply cover and shake the
appliance horizontally 3-4 times.
• Shake the appliance gently without tilting it.
(Fig. 8)
3. Open the water supply cover and pour out the
water from the appliance in the direction of the
arrow as shown. (Fig. 7)
Note: Repeat the above steps 2-3 times for
effective cleaning.
4. Wipe off any water from the appliance.
• Even if there are water scale deposits near
the water inlet or water level, the discharged
steam is not affected.
Cleaning the appliance. (Do not wash or
soak the appliance in water.)
I Wipe the appliance with a cloth moistened
with soapy water.