Panasonic CZ02RT11P - Manual (Page 6)

Operation manual
4
CZ-02RT11P
Remote controller
4PW15515-1
30 SCHEDULE TIMER BUTTON
This button enables or disables the schedule timer.
31 TIME ADJUST BUTTON
These buttons are used to adjust the clock or, when in
programming mode, to adjust the programmed action
time. Both buttons have an auto-repeat function.
32 TEMPERATURE ADJUST BUTTONS
These buttons are used to adjust the current setpoint
or, when in programming mode, to adjust the
programmed setpoint temperature (step = 1°C). Both
buttons are also used to adjust the day of the week.
33 OPERATION CHANGE/ BUTTON
This button is a multi-purpose button. Depending on
the previous manipulations of the user, it can have
following functions:
34 SETPOINT/LIMIT BUTTON
This button toggles between setpoint, limit operation
or
(programming mode only).
35 FAN SPEED BUTTON
This button toggles between L (Low), H (High), HH
(very High),
(Automatic).
36 AIR FLOW DIRECTION ADJUST BUTTON
This button enables to adjust the air flow direction.
37 AIR FILTER CLEANING TIME ICON RESET
BUTTON
This button is used to reset the air filter cleaning time
icon.
3. Setting up the controller
After initial installation, the user can set the clock and
day of the week.
The controller is equipped with a schedule timer that
enables the user to operate the installation
automatically; setting the clock and day of the week is
required to be able to use the schedule timer.
1 CLOCK SETTING FUNCTION
Hold down the button for 5 seconds. The clock
read-out and the day of week indicator will blink, both
can now be adjusted.
Use the & buttons to adjust the
clock. Each time pressing the time adjust button will
in/decrease the time by 1 minute. Keeping the
or button pressed will in/decrease
the time by 10 minutes.
Use the & buttons to adjust the day
of the week. Each time pressing the or
buttons will display the next or previous day.
Press the button to confirm the current set time
and day of the week.
If the controller, with blinking clock and day of week
read-out, is left untouched for 5 minutes, the clock
and day of the week will return to their previous
settings; the clock setting function is no longer active.
2 SETTING UP THE SCHEDULE TIMER
To set up the schedule timer, refer to chapter 6.
"Programming the schedule timer" on page 10.
1 select the operation mode of the installation
(FAN, DRY, AUTOMATIC, COOLING, HEATING)
2 toggle between minimum temperature and
maximum temperature when in limit operation