Panasonic ER1511 - Manual (Page 6)

6
English
Cleaning the blade
1. Brush off
any hairs
from the
clipper and
from around
the blade.
2. Remove the
blade and
brush off
the hairs
from the
blade edge.
3. Brush the hairs out from
between the stationary
blade and the moving
blade while pressing
down on the cleaning
lever to raise the moving
blade.
Lubrication
1. Apply a few drops of the
oil to the space between
the stationary blade and
moving blade.
Apply the oil to the clipper
before and after each use.
2. Set the dial to “2.0” and
then remount the blade
on the clipper.
•
Removing the built‑in rechargeable batteries
1. Remove the blades 1 and four screws 2 .
. Remove the spring 3 , the under cover 4 , and the blade holder 5 .
3. Remove the dial 6 and open the housing 7 , and then take out
two batteries 8 .
Disconnect the clipper from a household outlet.
Discharge the batteries completely before removing them.
Be careful not to short‑circuit the batteries.








WARNING ‑ Do not attempt to replace the batteries for the
purpose of reusing the clipper. This could result in the risk of fire
or electric shock.
Important notice regarding environmental protection
The built‑in rechargeable Nickel‑Metal Hydride batteries contain
substances that may be environmentally harmful. Please remove
the batteries before discarding your clipper.
For environmental protection and recycling materials
This clipper contains Nickel‑Metal Hydride batteries.
Please make sure that the batteries are disposed of at an
officially assigned location, if there is one in your country.
Please read “Information for Users on Collection and Disposal of
Old Equipment and used Batteries” on page 91.
•
•
•