Avaya ABT-34 - Manual (Page 8)

8
ABT-35H
PAIRING
PAIRING HEADSET AND BASE
The ABT-35/ABT-34 Bluetooth ® Headset Systems
are supplied with the headset and base unit
factory paired to each other. However, if you
have purchased a base unit separately, or if you
wish to use a replacement headset with your
existing base unit, the units must be paired as
follows:
1. On the base, press and hold both speak
volume fine adjust buttons until the blue talk/on
line indicator light and red power indicator light
(on the front of unit) start to flash.
2. On the headset, press and hold the listen
volume adjust + button and call control button
until the status indicator flashes red and blue.
3. Pairing is complete when the talk/on line
indicator on base illuminates solidly, and the
status indicator light on headset flashes blue.
Important: Make sure your headset is not
connected to any other Bluetooth device
when attempting to pair.
PAIRING HEADSET AND
MOBILE PHONE
Before using your headset for
the first time with your
Bluetooth mobile phone or
device, you must pair it with
that device. To pair, follow
these steps:
1. Turn on mobile phone. Place headset in pairing mode by
simultaneously pressing and holding listen volume adjust
button marked + (volume up) and call control button for 2
seconds. When status indicator light flashes red then blue,
release the buttons.
2. Use your phone’s menu to search for Bluetooth audio devices
and select “ABT-35H” when it appears on the display.
Note: In some circumstances the pairing process can take
up to two minutes to complete.
3. When the phone display asks for a passkey, enter: 0000.
Status indicator flashes blue, once the headset is successfully
paired. If pairing fails, try again starting with Step 1.