Asus M2N-L - Manual (Page 61)

ASUS M2N-L -
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode.
Configuration options: [Auto]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
OnBoard PCI IDE Controller [Enabled]
Enables or disables primary IDE controllers.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1/2]
Enables or disables the SATA0/1/2 IDE Interfaces.
Configuration options: [Disabled] [Device 0] [Device 0/1] [Device 0/1/2]
IDE Configuration
OnBoard PCI IDE Controller [Enabled]
Serial-ATA Devices [Device 0/1/2]
nVidia RAID Setup
Hard Disk Write Protect [Disabled]
IDE Dectect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
DISABLED: disables
the intergrated IDE
Controller.
ENABLED: enables
the intergrated IDE
Controller.