Alliance Laundry Systems NX30BVXA7 - Manual (Page 15)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 13 9002062
Installation/Operation Supplement
Removing the Transport Block
To prevent damage during transportation, machine has
been equipped with a transport block. To remove,
proceed as follows:
1. Place machine on level ground.
2. Remove service panels and back panel.
3. At rear of machine, lift at bottom of motor and
remove transport block if present. Refer to
Figure 4.
Figure 4
IMPORTANT: Do NOT lift motor by the pulley.
4. Remove the panel braces. Refer to Figure 5.
IMPORTANT: Do NOT remove panel braces. They
may be located in either the front or on the side and
rear of the machine. Refer to Figure 5.
Figure 5
5. Replace all panels removed.
CFD26N
1 Transport Block (Remove)
The machine must never be activated
before removing the transport block.
W618
WARNING
CFD26N
1
CFD515N
1 Panel Braces
CFD515N
CFD34N
1
1
CFD34N