Panasonic NN-SN733W - Manual (Page 6)

4
INSTALLATION AND GROUNDING
INSTRUCTIONS
Examine Your Oven
Unpack oven, remove all packing material and examine the oven for any damage
such as dents, broken door latches or cracks in the door. Notify dealer immedi-
ately if oven is damaged. DO NOT install if oven is damaged.
Placement of Oven
1. The oven must be placed on a fl at, stable surface. Place the front surface of
the door 3 inches (7.6 cm) or more from the counter top edge to avoid acci-
dental tipping of the microwave oven during normal use. For proper operation,
the oven must have suffi cient air fl ow. Allow 3 inches (7.6 cm) of space on both
sides of the oven and 2 inches (5 cm) of space on top of the oven.
(a) DO NOT block air vents. If they are blocked during operation, the oven may
overheat and be damaged.
(b) DO NOT place oven near a hot, damp surface such as a gas or electric
range, or dishwasher.
(c) DO NOT operate oven when room humidity is excessive.
2. This oven is manufactured for household use only. It is not approved or tested
for mobile vehicle, marine, or commercial use.
Installation
1. DO NOT block air vents. If they are blocked during operation, the oven may
overheat. If the oven overheats, a thermal safety device will turn the oven off.
The oven will remain inoperable until it has cooled.
WARNING
IMPROPER USE OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRIC SHOCK.
Consult a qualifi ed electrician or service person if the grounding instructions are not
completely understood, or if doubt exists as to whether the appliance is properly
grounded. If it is necessary to use an extension cord, use only a three wire extension
cord that has a three prong polarized grounding plug, and a three slot receptacle that
will accept the plug on the appliance. The marked rating of the extension cord should
be equal to or greater than the electrical rating of the appliance.
Grounding Instructions
THIS APPLIANCE MUST BE GROUNDED. In the event of an electrical short cir-
cuit, grounding reduces the risk of electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded.
• Plug into properly installed and grounded 3 prong outlet.
• DO NOT remove ground prong.
• DO NOT use an adapter.
PA_F0003BK20AP_Eng_PP01_0208.indd 4 PA_F0003BK20AP_Eng_PP01_0208.indd 4 2013-2-8 9:18:23 2013-2-8 9:18:23