Panasonic ES-LV81-K - Manual (Page 6)

6
English
Charge
Chargingusingtheself‑cleaningrecharger
Thoroughly wipe off any drops of water on or around the self‑
cleaning recharger so that it is dry before charging the shaver.
1 1 Inserttheappliancepluginto
theself‑cleaningrecharger.
2 2 Removetheprotectivecapand
thengentlyinserttheshaveras
shown.
3 3 PlugintheACadaptorintoa
householdoutlet. 1
3 2
The “Charge” course starts when attaching the shaver.
Turn the shaver off before inserting.
Check that the outer foil is not deformed or damaged when you
insert the shaver.
Wipe off any water droplets on the main body rear terminal.
You can charge even with the STATUS lamp of the self‑cleaning
recharger is blinking.
Charging is completed after approx. 1 hour.
If the shape of the plug does not fit the power outlet, use an
attachment plug adaptor of the proper configuration.
You can keep the shaver attached to the self‑cleaning recharger,
or connected to the AC adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
•
•
•
•
•
•
•
Chargingwithouttheself‑cleaningrecharger
You can also charge without the self‑cleaning recharger.
1 1 Inserttheappliancepluginto
theshaver.
2 2 PlugintheACadaptorintoa
householdoutlet.
1
2
You cannot operate the shaver while charging.
ReadingtheLCDpanelwhencharging
The LCD panel shows the remaining battery capacity from 0% to
100%, in 10% increments.
While charging After charging is completed
The indicators glow.
Battery capacity and Charge status
will light up and then turn off after 5
seconds.
After charging is completed, turning the power switch ON with
the shaver plugged in will cause Battery capacity and Charge
status to light up and then turn off after 5 seconds. This shows
that the shaver is fully charged. •