Anetsberger Brothers 14G - Manual (Page 13)

13
NOTE: The gas line of a new fryer installation
may contain a considerable amount of air that will
hinder immediate lighting. You may have to press
in the gas safety valve control knob as long as
several minutes before the pilot flame burns
steadily.
1. Ensure that the fryer’s thermostat knob is set
to OFF.
2. Open the gas supply line inlet valve to the
fryer by aligning the gas valve handle with the
gas line piping.
3. Open the front door and move the right pilot
viewing/lighting port cover aside.
4. Turn the gas control valve knob to align the
PILOT setting with the valve mark. Figure 6
shows the possible gas control valve knob
positions.
5. Press, and hold down, the valve control
knob to allow pilot gas to flow.
Model 14G, 14GU, 14GS, or 14GSU: Use
a match or lighter to ignite the pilot burner.
Model MX-14EG or MX-14EGU: Push
the spark igniter pushbutton several times,
until the pilot flame lights. (A match may also
be used to light the pilot flame.)
Continue holding down the control knob for
at least 30 seconds until the pilot flame
burns steadily without going out.
6. Release the control valve knob and observe
that the pilot flame remains lighted. Close the
right pilot viewing/lighting port.
7. Light the left pilot flame by opening the left
pilot viewing/lighting port and applying a
match to ignite the pilot flame. Close the
left pilot viewing/lighting port.
FRYER OPERATING INSTRUCTIONS
(Continued)
Figure 6. Gas Control Valve & Knob Positions
OFF PILOT ON
Valve Mark
8. Turn the gas control valve knob to align the
ON setting with the valve mark.
9. Turn the thermostat knob to the desired
temperature. Observe that the fryer’s main
burners light to heat the kettle.
OFF P
I L
OT
ON OFF
ON
P
I
L
O
T
OFF P
IL
OT
ON
OFF
PILOT
European Valve
Markings
ON
Normal operation of an
ANETS Fryer requires that the kettle is filled with liquid shortening above the
lower indent level, marked on the rear of the kettle, before lighting the fryer’s pilot and turning on the main
burner.
CAUTION: Shortening MUST be in liquid form to avoid scorching or discoloration and possible
damage to the kettle. Damage caused by melting solid shortening will NOT be covered by the warranty.
!
LIGHTING PROCEDURE
! CAUTION: Ensure that both pilot
viewing/lighting ports are closed, to
prevent excessive heat from damaging
the gas controls.