Panasonic HC-V250K - Manual (Page 15)

- 15 -
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1
Open the SD card cover and insert (remove) the SD card into (from) the card
slot B.
≥ Face the terminal side C in the direction shown in the illustration and press it straight in as far as
it will go.
≥ Press the center of the SD card and then pull it straight out.
2
Securely close the SD card cover.
≥ Securely close it until it clicks.
≥ Do not touch the terminals on the back of the
SD card.
≥ Do not apply strong shocks, bend, or drop the
SD card.
≥ Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
≥ When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or this
unit.
≥ Do not expose the terminals of the SD card to
water, dirt or dust.
≥ Do not place SD cards in the following areas:
j In direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant
difference in temperature (condensation
can occur.)
j Where static electricity or electromagnetic
waves occur
≥ To protect SD cards, return them to their
cases when you are not using them.
≥ About disposing of or giving away the SD
card. ( l 195 )
When using an SD card not from Panasonic, or one previously used on other equipment, for the
first time on this unit, format the SD card. (
l 37 ) When the SD card is formatted, all of the
recorded data is deleted. Once the data is deleted, it cannot be restored.
Access lamp
[ACCESS] A
≥ When this unit is accessing
the SD card, the access
lamp lights up.

 