Panasonic MC-UG323 - Manual (Page 46)

- 46 -
Four Screws
Quatre vis
Cuatro Tornillos
➢ Lay unit on floor bottom up with
nozzle flat.
➢ Install the four screws to the nozzle
cover.
➢ Route nozzle hose to hose holder.
Align nozzle hose bracket with
retaining bracket on body and slide
down unit it clicks into place.
➢ Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
Cleaning Agitator
➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ Remove lower plate. (See
REPLACING BELT, p. 42, 44)
➢ Cut off any hair, thread, string,
carpet pile, and lint entangled
around agitator with a pair of
scissors.
➢ Remove agitator. (See REPLACING
BELT, p. 44)
➢ Remove any string or debris located
on the end caps, washers or agitator
shaft.
➢ Reinstall agitator and lower plate.
(See REPLACING BELT, p. 44)