Panasonic EHHS95 - Manual (Page 16)

16
English
Cleaning
Clean the straightener after it has cooled and with the plug
removed from the household outlet.
Cleaning the nanoe™ Outlet ( H)
● Clean the nanoe™ Outlet about once per month.
● This maintenance allows the straightener to sustain the
generated level of nanoe™ over a long period.
1 1
Shut the Iron Plate ( G) with the Open/Close
Lock ( D).
2 2
Damp the end of the Cleaning Brush ( L)
(included) with store-bought purifi ed water or
tap water.
3 3
Deeply insert the
Cleaning Brush (
L)
(included) into the
nanoe
TM Outlet ( H).
Brush three fl at portion
(
a ) and pin-shaped
portion ( b ) by moving
the Cleaning Brush ( L)
(included) right and left
for about ten times.
(nanoe
TM Outlets are
located on both sides.)
b a
(On both sides)
• Instead of using the Cleaning Brush, thin cotton swabs
(for babies) can also be used.
Cleaning the straightener
● When this unit has become dirty or styling products, etc.
have gotten onto it, please soak a rag in soapy water, wring
it out, and wipe the unit clean.
● Do not use alcohol, thinner, benzine or remover.
Doing so may crack or discolor the surface of the
straightener.
Troubleshooting
Problem
● Sparks are generated inside the nanoe™ Outlet.
● The nanoe™ Outlet emits a noise (crackling noise).
Possible cause
Dust, styling products, etc. are
adhered to the pin-shaped
portion where nanoe
TM is
generated.
Your hair is too wet.
Action
Clean the nanoe TM Outlet to
remove any adherents.
Dry your hair until it is slightly
wet.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.