Avayon DXP-10P - Manual (Page 18)

Playing a Disc
Turning ON /OFF the player
To turn on the Player
1. Slide POWER on the Player to ON, this will put the Player on standby mode.
2. Press ► on the Player to turn on the power.
3. You can also press STANDBY on the remote control to turn on the power.
To put the Player on standby mode
Press STANDBY on the remote control.
To turn off the power
Slide POWER on the Player to OFF.
Preparation for Playback
1. Make sure the unit has the power either from the battery pack or the AC adaptor.
2. Loading a disc, following these steps:
Open the top cover by pushing the latch to the right and lift the top cover.
Press the OPEN button to open the disc compartment cover.
Place a disc into the tray with the label side facing up.
Close the disc cover.
3. Slide INPUT/OUTPUT to OUTPUT (located on the side of the player).
4. Turn on the Power
Slide POWER to ON.
Press STANDBY on the remote control to turn on the Player. You can also press PLAY ( ► ) on the Player to turn on.
PLAY/PAUSE
Press ► on the Player or PLAY/ PAUSE (►►║ ) on the remote control to start play.
STOP
Press ■ once to stop playback.