Overview, Power-on self-test – ADIC 4000 User Manual
Page 43
Overview
5-3
5-
Overview
This section describes normal operating features of the
4000/7000DLT Series. Additionally, it explains how, and
when, to clean the tape head. This section also describes how
to clean the enclosure.
Power-on Self-Test
When you turn system power ON, the DLT drive performs a
Power-on Self-Test (POST). The sequence of events is:
•
The LEDs on the right front panel of the DLT drive will
turn on sequentially from top to bottom. All LEDs will
remain ON for a few seconds.
•
The LEDs on the left front panel will turn ON at the same
time for about three seconds and then turn OFF.
•
The
Operate Handle Write Protected
and
Use Cleaning
Tape
LEDs will turn OFF. The
Tape in Use
LED will
blink while the tape drive initializes.
•
If your external SCSI bus terminator has a Term Power
LED it should also be illuminated.