AstroStart 4204U User Manual
Page 7
5
HOOD STATUS
Car identification
ALARM STATUS
SHOCK SENSOR STATUS
TRUNK STATUS / OTHER SENSOR
PRE-SHOCK STATUS
Valet mode status
Lock commands status
Ready to start / Ignition status
Engine running status
Low Battery
DOORS STATUS
R
EPLACING THE BATTERY
The LCD of the 4-button remote has a battery icon telling you when to replace the battery.
We strongly recommend keeping a replacement battery in your glove compartment.
The remote controls require one AAA battery. See your dealer for spare batteries.
To replace the battery, slide the latch sideways and remove the battery cover on the back of the remote control case,
remove old battery and replace it with a new one.
Make sure the battery is placed the right way (see pictogram inside the cover).
CONFIRMATIONS EMITTED BY THE
4-
BUTTON BIDIRECTIONAL REMOTE
An audible confirmation (piezo) and a visual
confirmation (LCD display) are emitted each time a
command is transmitted.
The following diagram shows the usefulness of each
segment of the display.
Display confirmations will be visible for 4 seconds.
Descriptions in capital letters show confirmations
pertaining to the security system’s functions.
CONFIRMATIONS EMITTED BY THE
5-
BUTTON BIDIRECTIONAL REMOTE
An audible confirmation (piezo) and a visual
confirmation (LCD display) are emitted each time a
command is transmitted.
The following diagram shows the usefulness of each
LED of the display.
In most cases, confirmations remain visible for 5
seconds.
*
CONFIRMATION OF
A
LARM
ON
RECEIVED ONLY AT TIME
OF ARMING WHEN SYSTEM IS EQUIPPED WITH AN ALARM
.
UNIDIRECTIONAL REMOTE
A unidirectional remote is included in the 5204U kit to accommodate an occasional driver. It has no display indicating the
status of the security system or confirming the action of commands that are transmitted.
An audible confirmation (piezo) and a visual confirmation (LCD display) are emitted each time a command is transmitted.
The remote is powered by three lithium batteries CR-2016 or equivalent. It is strongly recommended
to keep a set of replacement batteries in the glove compartment.
To change the batteries, simply remove screw on back of remote, remove worn batteries and insert
fresh ones.
Ensure the batteries are correctly oriented. See illustration at right.
A pictogram in the bottom of the case shows correct battery orientation.
L
EGEND
S
OLID
F
LASHING
LED
G
R
GREEN
R
ED
G G
R R
G
R
EADY FOR START
R
U
NABLE TO START OR
E
NGINE STOP
G G
E
NGINE RUNNING
R R R R R R G G G G
A
LARM WITH ZONE IN VIOLATION
R R R R R R
P
RE
-
SHOCK
R
D
OOR LOCKED
& A
LARM
ON*
R R
G G
D
OOR OPEN FOR MORE THAN
5
MINUTES
G
D
OOR UNLOCKED
G
G
V
ALET
ON
G
O
THER FUNCTIONS
/ V
ALET
OFF
R
N
O CONFIRMATION SIGNAL RECEIVED
G
T
RUNK COMMAND RECEIVED
G
G
T
RUNK OPEN FOR MORE THAN
5
MINUTES