AeroBed Family Quick Pool with Built-In Seats - Manual

Thank you for joining the AeroBed ® family by purchasing one of our premium products. You can expect top-notch quality, innovation, and imagination from every AeroBed
product. You are about to enjoy the comfort of an AeroBed pool. It is your responsibility to read and always follow the safety, care, and maintenance instructions for your
new AeroBed product. Always instruct and supervise others on your pool’s proper use, maintenance, and safety.
IMPORTANT: Preparation of your AeroBed product requires no tools. Use of tools may damage your pool.
7966 Rev 6/08
107 Pump / Pool Instruction Manual
IMPORTANT SAFETY INFORMATION AND WARNINGS
WARNING: THE USE OF THIS PRODUCT REQUIRES COMPETENT ADULT SUPERVISION AT ALL TIMES. THIS PRODUCT IS NOT RECOMMENDED FOR
CHILDREN UNDER SIX (6) YEARS OF AGE.
Pool
POOL FENCING LAWS IN YOUR AREA MAY AFFECT THIS PRODUCT. IT IS YOUR RESPONSIBILITY TO KNOW AND FOLLOW YOUR LOCAL LAWS.
WARNING: NOT A LIFESAVING DEVICE. USE ONLY WITH ADULT SUPERVISION. Never leave children unattended in or near water.
- Do NOT dive or jump into or on pool or allow children to do so. Warn children that improper use can be fatal.
- To be used only for recreational swimming. Do not use for diving, as a baby playpen, trampoline, boat or for any other recreational activity.
- Place the pool in a safe area before use, making sure that there are no sharp edges, steps, drops or breakable items nearby.
- This pool is made of plastic and may melt or burn if it comes in contact with any flame or heat source. Keep all flame, heat sources or other hot objects
away from this product.
- Guard against slips and falls by avoiding all rough play in or around pool.
- NEVER place pool in another body of water.
Rechargeable Pump - For outdoor use.
WARNING: The Air Release Valve is made of several small parts which could pose a choking hazard. Keep all parts away from children under 6 years of age.
WARNING: Pump is not a toy-children must be supervised at all times.
WARNING: Risk of electric shock. Do not expose to rain. Store Indoors.
- Pump charger is an electrical device. Do not use in or around water.
- Charger to be used indoors only.
- Do NOT place pump or charger where they could fall or be pulled into the water.
- Not recommended for children under 6 (six) years of age.
- The pump contains nickel-cadmium batteries.
- The pump should not be incinerated.
- The pump should not be overcharged or reverse charged.
- The pump batteries are not replaceable. Do not attempt to replace them.
- Do NOT charge the Ni-Cd battery pump with any other charger than the one provided with the pump.
- Do NOT attempt to dissemble, repair, or service the pump. No user serviceable parts are contained inside. Contact Aero Products International, Inc. at
1834 Walden Office Square, Third Floor, Schaumburg, IL 60173 for repair or servicing information.
This is the closed position. Open Air Release Valve Close Valve Using 2 Thumbs
3. Remove black cover(s) from the Inflation/Release Valve(s) and pump. Attach pump to valve(s) located on the side of the pool.
4. Turn pump clockwise until the pump turns on.
5. When product is inflated, turn pump counterclockwise and remove. A high pitch whine from your pump will signal that your pool
is fully inflated. Pool will not over-inflate.
6. Detach pump by turning it counter-clockwise.
7. Place covers back on Inflation/Release Valve(s) and pump.
RECHARGEABLE Ni-Cd PUMP - For Outdoor Use.
WARNING: Risk of electric shock. Do not expose to rain. Store Indoors.
IMPORTANT: PUMP MUST BE CHARGED FOR 24 HOURS PRIOR TO THE FIRST INFLATION. Use the AC adapter to charge your new Aero
pump for 24 hours. For maximum performance, be sure to fully discharge pump before recharging. After initial charge and use, charge pump for
12 HOURS at a time. Charging your pump for periods shorter or longer than 12 hours will substantially decrease the life of your Ni-Cd pump. In
an emergency, a 3 hour charge will provide one inflation, however, continued charging for 3 hour periods will substantially decrease the life of
your Ni-Cd pump.
IMPORTANT: ALWAYS store pump and charger in a cool, dry place. DO NOT allow pump or charger to get wet. Allowing pump and/or charger
to get wet will void your warranty.
IMPORTANT: Charger to be used indoors only.
TO CHARGE / RECHARGE:
a) First, remove pump and charger from box.
b) Second, remove tiny rubber plug from hole on the back of the pump.
c) Insert the charger’s mini-plug in the hole.
d) Third, plug the charger unit into any standard 110V (or 220V depending on your local service) electrical outlet and let it charge for 12 hours
(24 hours on initial charge).
NOTE: For best pump performance, you must completely drain the charge from your pump prior to recharging. For directions, see discharge
section below.
Prior To Inflation:
a) Unplug the pump after it has been charged for 12 hours (24 hours on initial charge).
b) Remove charger unit from the electrical outlet and the mini-plug from the pump.
c) Re-insert the tiny rubber plug into the hole on the back of the pump.
NOTE: Pump will not run while charger is plugged into an electrical outlet.
To Discharge:
a) Place pump on valve as if to inflate product.
b) Allow pump to run until the pump motor dies down.
NOTE: When properly used, your pump will hold a full charge for approximately 90 days. When storing pump for longer than 90 days, fully
discharge and recharge pump every 120 days. This will help maximize pump life.
WARNING: PUMP SHOULD ONLY BE USED WITH AERO ADAPTER PROVIDED. DO NOT USE WITH ANY OTHER ADAPTER.
IMPORTANT: PUMP CONTAINS NICKEL-CADMIUM BATTERIES. BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
INFLATION
IMPORTANT: Prior to inflation, find a level spot to inflate your pool.
1. Remove your new AeroBed pool from the packaging and unfold until it lies flat on the ground.
2. Make certain the Quick Air Release Valve located at the head of the pool is closed. If the Air Release Valve is open, close it by using 2
thumbs to push cover and snap into valve. Be careful to avoid pushing valve cover to the right or left as it snaps into the valve opening.