Speed sensor wire, Bracket – CatEye MSC-2Dx User Manual
Page 3
Advertising
Attach the speed sensor temporarily to the right front fork.
Adjust the sensor
2
and the magnet
0
referring to the
above A and B . After adjusting, tighten the screw
9
and the
magnet
0
.
Secure the wire along the fork using the nylon ties
5
and
wind it round the brake cable up to the handlebar.
Attach the bracket rubber pad with holder
8
to the bracket
1
and mount it to the handle bar.
Reference: If the clearance between spoke and front fork
is wider than 5mm, mount the sensor band
3
and
4
in an
opposite way as shown.
Speed Sensor
Wire
Caution:
Allow enough wire clearance in the area marked
with
.
Reference: If it does not fit well, use the rubber pad
7
.
Bracket
front fork
-3-
Advertising