CatEye TL-AU100 - Manual

THIS IS
MADE OF
RECYCLED
PAPER .
WARNINGS:
CO.,LTD.
REPLACING BATTERIES:
(*1)
(*2)
PAD
ø18.0~40.0mm
ASSEMBLING THE TL-AU100BS:
HP-5
ø19.0~22.8
SP-5
ø23.5~27.2
SP-6
ø26.5~30.5
SP-7
ø28.8~32.5
SP-8
ø31.0~34.5
SPARE ACCESSORIES
Before using the product, please thoroughly
read this manual and keep it for future
reference. Run times are based on use with 1.5
volt alkaline batteries. Use of rechargeable
batteries may result in a decrease of run time
and brightness.
When using this light
always make sure to slide
the light onto the bracket
completely (until it "clicks"
into place) .
2-8-25,Kuwazu,Higashi Sumiyoshi-ku,
OSAKA,Japan 546-0041
www.cateye.com.
• Although this light is being supplied with the endless clamp only, the reflector on this light only
complies with BS6102/2 when used with the fitting clamps SP-5, SP-6 or SP-7 available separately.
• Before every ride, check to see the TL-AU100BS is securely attached to the bicycle.
• Incorrect installation of the batteries can damage the TL-AU100BS.
• Do not use combinations of fresh and old batteries or different types of batteries. Always
remove expired batteries.
• If the TL-AU100BS does not turn on, the batteries may be at the end of their useful life. Replace
them with new ones.
• The battery life will vary depending on the conditions of use.
• Always Keep the reflector clean.
For UK Consumers
When used in constant flashing mode this light complies with the Road Vehicles Lighting Regulations
2005 No.2559. When used in constant mode, this light complies with British Standard 6102/3.
1. Install the rubber pad on the clamp as shown and
attach it to the seat post.
2. Assemble the bracket to the clamp with the screw but
do not tighten completely.
3. Insert the light body into the bracket until it clicks into
position.
4. Adjust the angle of the light so that:
• The reflector will face directly backwards (*1).
• The reflector will be perpendicular to the ground (*2).
5. Tighten the screw securely.
Attach the band temporarily
to the seat post.
1. Use a coin to remove the reflector.
* Using a large diameter coin
2. Insert two new AA size batteries (alkaline recommended)
and make sure of the correct polarity.
3. Install the reflector back to it's original position.
#544-0980
BRACKET
#544-0892
UNIVERSAL BAND: ш18.0~40.0