COOK Laboratory Exhaust - Manual (Page 6)

3.1 Rigging a Single Piece Unit
Note: Use all of the lifting points provided on the equipment.
Loren Cook will not be responsible for damages incurred from not using all of the lifting points.
If the equipment is to set on a curb, install the curb gasket to the curb only. Do not apply curb
gasket to the unit
’s base frame. The curb gasket is ½’ x 1 ¾” and is supplied with the unit.
CLEVIS
HOISTING STRAPS
OF EQUAL LENGTH
SPREADER BAR M UST BE
LONG ENOUGH TO HOLD
HOISTING STRAPS AWAY FROM
UNIT TO PREVENT DAM AGE
TO CABINET.
CURB
GASKET
OPTIONAL FACTORY
SUPPLIED CURB
LIFTING LUGS
WHEN M ORE THAN TWO LIFTING LUGS ARE SUPPLIED
ON EACH SIDE OF UNIT, AN ADJUSTABLE TURN-
BUCKLE MUST BE USED ON EACH SIDE TO EVEN
THE HOISTING LOAD ON EACH HOISTING STRAP. THIS
IS M ANDATORY TO PREVENT DAM AGE TO THE UNIT.
NOTE: ALL LIFTING LUGS SUPPLIED MUST BE USED
FOR EACH LIFT!
Remove all of the sheet metal covers marked “Remove—For Shipping Purpose only” that may
interfere with the installation. When the unit is lifted, check the bottom for truck supports.
These supports will be 2” x 2” tubing screwed to the bottom of the unit to provide support to
units whose width exceeds that of the trailer that it was shipped on. Remove these as the unit is
lifted as they may interfere with the installation.