AEG BP7614000 - Manual (Page 23)

The pyrolytic cleaning procedure cannot start:
– If you do not remove the core temperature sensor plug from the socket, the display
shows „C2“
– If you do not close the oven door correctly, the display shows „C3“.
2.
Remove the worst of the residual dirt manually.
3. Set the Pyrolytic cleaning function (refer to "Oven functions").
4. Touch to activate the Pyro cleaning function.
5. Touch or to set the duration of the cleaning procedure:
– P1 1:30 for a low degree of dirt
– P2 2:00 for a usual degree of dirt
– P3 2:30 for a high degree of dirt.
Touch to confirm.
You can use the End function to delay start of the cleaning process.
During the Pyro cleaning the door is locked. The symbol and the bars of the heat indica-
tor come up, until the door unlocks again.
The door unlocks when temperature inside the oven is under safety condition and Pyro
cleaning is finished.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashes
in the display after every deactivating the appliance for the next 10 seconds.
The cleaning reminder goes off from the display:
• After end of the pyrolytic cleaning function
• When you deactivate it in the Settings menu (refer to "Settings menu")
Telescopic shelf runners
You can remove the telescopic runners to clean the side walls.
Removing the telescopic runners
1.
Pull the front of the telescopic runners
away from the side wall.
Care and cleaning 23