EXONIC EXD 6505 - Manual (Page 20)

Radio Operation
-20-
In Radio Mode, Touch and keep
for more than 2’s the
section
on the touch screen to active
APS
automatic station storage. The radio
searches within the current frequency
band, e.g. FM1, for the stronger signal
level until the search cycle has finished .
The six strongest stations are then
allocated to the corresponding storage
locations . Then the station of the first
storage location is set .
APS
Touch to preset station
MODE
SEL VOLUME+ VOLUME-
MUTE ON
FM1 87.60
MHZ
1 2 3 4 5 6
FLAT
NO-DISC
12:04
DX ST
Automatic Memory Storing &
Program Scanning
Automatic Preset Setup
Touch it to select the other item,
it will display the following
as below :
S-WOOFER
FM1 87.60 MHZ
APS
STEREO/MONO
FLAT
NO-DISC
12:04
DX ST
BND
PAIR REDIAL DIAL
DSP
Touch to select
Scan Function
In Radio mode, briefly touch the
section on the touch screen ,
the radio briefly plays all the
APS
preset stations of the frequency band .
APS
Touch the section on the touch
screen (or press LO/DX button on the
remote control ) to select the LOCAL
or DX mode .
( You can choose between the LOCAL
and DX(DISTANCE) mode for local or
long-distance traffic news . )
“ LOC ”
To tune in strong-singnal FM
Station only (LO/DX function)
Setting Memory
Touch the screen of the sections “ 1-6 ”
With this system, a total of 30 stations
can be stored in the memory of six
buttons. Each band stores up to six
preset stations. The stations might be
FM1, FM2, FM3, AM1(MW1), and
AM2(MW2) band.
The operation is as below :
-Retrieve a preset station
1-6 sections Touch the briefly to retrieve
a station which had been stored in the
memory in advance the chose number
is shown on display .
-Store in Memory
>
Select the frequency band
> Select the station
> Keep the desired memory key pressed
in until the station is heard again after a
brief interruption .