EXONIC EXD 7095 - Manual (Page 21)

Touch Screen Operation
-21-
When an FM stereo broadcast is
hard to receive
Press ST/MO button on the remote
control to select the MONO or STEREO
mode . (When Stereo mode is activated,
the ST symbol will appear . )
Automatic Search
During Radio mode, touch and hold
(for more than 2’s ) the screen of “ / ”
section to start search for a radio
station automatically .
Start Searching For a Station
During Radio mode, briefly touch the
screen of “ ” section to increase
frequency by one step of channel
spacing .
Briefly touch the “ ” section to
decrease frequency by one step of
channel spacing .
Manual Search
In any modes, touch the “ ” ICON on
the touch screen to enter the main menu,
the information will display :
RADIO mode
Touch the RADIO ICON in home menu
to enter the RADIO mode:
08:16 08:16
AM AM
DX DX ST ST FLAT FLAT SWF SWF
FM1 FM1
108.00 108.00
MHZ MHZ
5 5
CH CH
1 1 2 2 3 3
4 4 5 5 6 6
87.50 87.50 90.00 90.00 98.00 98.00
87.50 87.50 108.00 108.00 106.00 106.00
BAND BAND APS APS EQ EQ VOL+ VOL+ VOL - VOL -
EXONIC EXONIC
1 2 3 4
To tune in strong-singnal FM
Station only (LO/DX function)
touch the screen of “ ” ICON to enter
the home menu, then touch the “ SET ”
icon to enter the setting menu, the
message will display as below :
The touch buttons on the lower of the
touch monitor:
1. Power button
in any modes, touch the “ ” ICON
to switch the unit off . The monitor
will draw in automatically .
2. Button
Touch this range to adjust the angle of
the monitor upward until your desired
angle .
3. Button
Touch this range to Open/Close the
monitor .
4. Button
touch this range to adjust the angle of
monitor downward until your desired
angle .
Selecting The Frequency Band
Touch the screen of “ BAND ” section
repeatedly to select the band , the
message will show in turn :
FM1 FM2 FM3
AM2(MW2) AM1(MW1)
LCD display on the front panel will
display as below :
FM3 BAND
FM3 87.50
ST