Nor-Lake AdvantEDGE Countertop Merchandiser - Manual (Page 2)

02/13 Rev. A 151629
3. Installation
After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
3.1 Installation Instructions
A. Always ensure that your merchandiser is installed on an even floor/counter.
Do not install the merchandiser under direct sunlight or near heat sources.
B. Allow a minimum gap of 100 mm (4”) at the top, 100 mm (4”) at the rear and 50 mm
(2”) at sides of the cooler.
Not following the instructions might cause high-energy consumption and poor performance.
C. Electrical connection: if the power cord supplied is not long enough, do not use an
extension lead. An electrician must fit an electrical socket closer to the merchandiser.
Never allow the merchandiser to be connected to an extension lead on a permanent
basis.
D. The merchandiser must stand upright for at least one hour prior to start up after
transportation.
3.2 Connection to the electrical supply
Connect the CTM to a 110-120V 60Hz power supply. Do not use extension cables. Clean the
interior of the CTM with the use of mildly soapy water. The glass surface should be cleaned using
a window-cleaning agent.
4. Maintenance
BEFORE PROCEEDING WITH ANY CLEANING OR MAINTENANCE PROCEDURE, UNPLUG
THE CTM!
4.1 Preventative Maintenance
A. Clean the condenser, at minimum, two times per year, using a vacuum cleaner.
B. Clean the interior of the CTM with the use of mildly soapy water. The glass surface
should be cleaned using a window-cleaning agent.
4.2 Cleaning
It is important to clean the merchandiser twice a year. In order to avoid mold formation, smells,
etc., the product compartments must also be thoroughly cleaned. The interior of the CTM has to
be cleaned with a mildly soapy cloth.
Remember to disconnect the unit from power before cleaning the CTM’s interior or exterior.
4.3 General User Information
The thermostat is located inside of the cooler. The thermostat is factory set to an ideal condition.
If you require a higher temperature (warmer), turn the thermostat control counter clockwise. If you
require a lower temperature (colder), turn the thermostat control clockwise.
4.4 Operation
Under normal conditions, evaporator fan is on when compressor is on.