Nor-Lake Undercounter BOD Refrigerator Incubator - Manual (Page 10)

Page 10 04/14 Rev. B 151749
User Interface
Installation
For the panel fastening, two flaring head screws must be used with a major
diameter of max. 3.9 mm.
• Carry out all the necessary electrical connections.
• Insert the instrument in the panel hole and make the connected cables return
to their place and check that the gasket is placed correctly. Keeping the
front in its position by pressing it in the middle, screw the two side screws
until the front is fastened. Don’t fasten too much to avoid compressing the
gasket excessively.
• Snap on the front plate
Wire Detail