Setup for pressure – Pulsafeeder PULSAlarm User Manual
Page 10
10
4. Setup for Pressure
Pumps incorporating pressure leak detection are shipped from the factory with the system fully
set up to work at full pump pressure. No further setup is required. The standard factory barrier
fluid is silicone oil, if any other customer-specified media is used it must be compatible with
construction materials. The system will require proper setup after maintenance or repairs, see
the following page for the proper procedure.
Figure 5 – pressure system
T
HE BARRIER FLUID USED TO PRIME THE SYSTEM WILL VARY WITH THE APPLICATION
.
T
HE FLUID SELECTED MUST BE COMPATIBLE WITH THE MATERIALS OF CONSTRUCTION
USED IN THE DIAPHRAGM AND DETECTION ASSEMBLY
.
I
T SHOULD ALSO BE COMPATIBLE
WITH THE PROCESS FLUID AND THE PROCESS CONDITIONS
.