Vaddio ClearVIEW HD-18 - Manual (Page 4)

ClearVIEW HD-18
ClearVIEW HD-18 Manual 341-885 Rev. C Page 4 of 14
5. RS-232 In & IR Out – The RS-232 accepts VISCA protocol for camera control, as well as transmits
IR signaling received by the IR receivers, which can be transmitted to third party devices.
6. DIP Switch Settings – Settings for IR remote, baud rate, SD output format, and image flip can be
configured on these switches. See page 5 for additional information on switch settings.
7. HD Video Select – A rotary switch allows the user to choose the component HD output video
resolution and format. See page 5 for additional information on switch settings.
8. 12 VDC Input – Power input for the standard, ClearVIEW HD-18 camera power supply.
9. YPbPr Video Output – Component HD video is fed through the DB-15 connector.
10. SD Video Output – Standard definition video is fed through the BNC connector.
11. EZ Power/Video Port – This RJ-45 connector is only used with the Quick-Connect Short Range
break-out box.
12. Slot for Optional Cards – Optional slot cards can be plugged into the ClearVIEW HD-18 camera.
First Time Set-up with the ClearVIEW HD-18:
ClearVIEW HD-18 was designed to be exceptionally easy to use and operate. There is documentation at
the back of the manual for pin-outs for all of the connectors on the ClearVIEW HD-18 camera.
Getting Started:
1.
First, set up the HD and SD output resolutions for the camera, along with IR output, baud rate and
image flip. See position settings on the following page for the switches that are found on the back
of the camera (see 6 & 7 on Figure 3).
5
6
7
8
9
10
11
12
Figure 3: ClearVIEW HD-18 camera (back)