Vaddio DomeVIEW Flush Mount Dome - Manual (Page 5)

Vaddio DomeVIEW Flush Mount Dome Installation and User Guide - Document 341-443 Rev C1
Page 5 of 12
5) Attach the camera mounting stage (6) to the stand offs (7) with three 8-32 x .5” flat head screws (5).
Canon VC-C50iR Camera only:
6) Attach the EZCamera Cabling Shoe (4 – Figure 3) to the Canon VC-C50iR.
7) Attach the camera (3) to the camera mounting stage (6) with two 8-32 x .5” pan head screws (2) and two
#8 lock washers (see Figure 3). Skip to Step 12.
Sony EVI-D70 Camera only:
8) Image Flip Switch, IR Select Switch and other Mode switches (set switches prior to powering up camera)
a. Set the Image Flip dipswitch on the back of the EVI-D70 camera to the ON position. The
camera will be inverted in the dome enclosure and the image needs to be flipped.
b. When using the IR Remote control in an environment with multiple cameras, set the IR Select
Switch frequency setting to 1, 2 or 3 to avoid having the IR remote control more than one
camera at a time.
c. Check the full-length manual for the EVI-D70 camera for other mode switch settings. The
manual is available on the Vaddio website (www.vaddio.com).
9) Attach the EZCamera Cabling Shoe (4 – Figure 4) to the Sony EVI-D70.
a. When mounting a Sony EVI-D70 without the EZCamera Cable System - skip this step.
10) Attach the Camera Base Plate (9) to the camera (3) with the provided ¼”-20 x .5” screw (10).
11) Attach the camera (3) and camera base plate (9) to the camera mounting stage (6) with four 8-32 x .5”
pan head screws (2) and four #8 lock washers (see Figure 4).
Figure 4: Exploded View of DomeVIEW Flush Mount Dome for Sony EVI-D70