Vaddio In-Wall Enclosure for Sony EVI-HD1 User Manual

Page 3

Advertising
background image

IN-Wall Enclosures

INSTALLATION (continued):

5) Remove the box from the wall and install the wall anchors.

6) Pull the cabling through the conduit knock-out and push the back box back into the opening. Be sure

to leave enough slack in the cable to enable termination and the freedom to push the cable back into
the wall cavity when the camera is attached to the platform. Fasten the enclosure to the wall with the
screws supplied into the wall anchors.


7) Next, place the Camera Platform onto the bottom of the Back Box, and screw the platform down with

the four flat head machine screws (Figure 4).

8) The face frame has four screw holes for mounting the frame to the back box. The steps for installing

the face frame are as follows:

a. On the sides of the face frame, there are four holes (Figure 4) for attaching the Face Frame

to the Back Box with the supplied white pan head machine screws.






Screw holes for
mounting the
Face Frame to
the Back Box






Camera
Platform

Face
Frame





Figure 4:

Back of the face frame and front of the IN-Wall box enclosure. The four holes on the face frame match up with the
threaded holes in the enclosure and are screwed into place.



b. If an EZIM is to be installed in the Back Box, connect the break out cable to the EZIM, then

screw the EZIM into place. If you are using standard cabling for the PTZ camera, those
cables can be run through either one of the conduit knock-outs, or the slot at the bottom of
the Back Box. For the EVI-D70, attach the EZ Camera Shoe to the back of the camera.

c. Connect the CAT-5 cables to the EZIM, making sure that the cables are connected to the

appropriate ports. NOTE: Plugging the wrong CAT-5 cable into the wrong port can damage
either the Quick-Connect system or the camera and void the warranty.


d. Next, connect the break out cables to the PTZ camera, and place the camera on the shelf.

Attach the camera to the camera using the appropriate screws supplied with the mount.







IN-Wall Enclosures - Document 341-744 Rev. C

Page 3 of 4

Advertising