Vaddio Off-Set Drop Down Mount - Manual (Page 2)

Offset Drop Down Mount
Document Number 341-710 Rev. B Page 2 of 4
Step 5:
Thread the camera platform bottom threads of the offset pipe until the platform bottoms out on
the hex jam nut applied in Step 4 (at least 5 rotations). Back the platform off until it is lined up
with the offset pipe (see Figure 2).
Step 6:
Tighten the jam nut until it is seated against the mounting nut on the camera platform. Using a
wrench, tighten the jam nut down onto the camera platform (see Figure 3).
Step 7:
For Vaddio WallVIEW PRO and CCU Installations: Connect the EZIM Break-out cable to the
EZIM.
Step 8:
Place the camera onto the camera platform and connect all necessary cabling to the back of
the camera.
Step 9:
Use the supplied ¼”-20 screws, feed the screws through the slot on the bottom of the camera
platform, and tighten them to the ¼”-20 threaded holes on the bottom of the camera.
Step 10:
If the third-party pipe hardware allows for cabling to be passed through, feed the cables out the
cable pass-thru on the side of the offset pipe.
Figure 2: Side view of
Camera Platform with
Jam Nut connected to
offset pipe.
Figure 3:
Front view of
offset mount.