Asus CUV266-DLS - Manual (Page 38)

38 ASUS CUV266-DLS User’s Manual
3. HARDWARE SETUP
Connectors
3. H/W SETUP
7) CPU Fan and Chassis Fan Connectors
(CPU1_FAN, CPU2_FAN, CHA_FAN)
The three fan connectors support cooling fans of 350mA (4.2 Watts) or less.
Orient the fans such that it blows air across the onboard heat sinks instead of the
expansion slots. The fan wiring and plug may vary depending on the fan
manufacturer. Connect the fan cable to the connector making sure that the black
wire matches the ground pin. (NOTE: The “Rotation” signal should be used
accordingly for a specially designed fan with a rotation signal. You can monitor the
Rotations Per Minute (RPM) using ASUS PC Probe (see 6. SOFTWARE
REFERENCE).
8) USB Headers (10-1 pin USB2_3, USB4_5)
If the USB port connectors on the back panel are inadequate, two USB headers are
available for four additional USB port connectors. Connect a 2-port USB connector
set to a USB header and mount the USB bracket to an open slot in the chassis.
WARNING! Make sure to connect the fan cables to the fan connectors. Lack of
sufficient airflow within the system could cause damage to the motherboard.
These are not jumpers, do not place jumper caps over these connectors!
®
CUV266-DLS
0 1 0 1 0 1 0 1
CUV266-DLS 12-Volt
Cooling Fans
CPU2_FAN
GND
Rotation
+12V
CHA_FAN
CPU1_FAN
GND
Rotation
+12V
GND
Rotation
+12V
®
CUV266-DLS
01 01 01 01
CUV266-DLS Front Panel USB Header
USB2_3
USB4_5
USB Power USBP4
–
USBP4+ GND NC
USB Power
USBP5
–
USBP5+
GND
1 5
6 10 USB Power USBP2
–
USBP2+ GND NC
USB Power
USBP3
–
USBP3+
GND
1 5
6 10