Vaddio ProductionVIEW Rack Enclosure - Manual (Page 3)

ProductionVIEW Rack Enclosure
ProductionVIEW Rack Enclosure - Document 341-722 Rev. B Page 3 of 4
Installation (continued)
7. Repeat the process for the other side of the shelf.
8. Fasten the front of the sliding shelf to the Enclosure using four (4) 10-32 rack screws (see below).
9. Test the shelf to confirm that it slides in and out smoothly, and then tighten all of the screws down.
10. Slide the Shelf out, and match the holes in the shelf with the angle brackets for the ProductionVIEW console.
Slide the four (4) 8-32 x 3/8” screws through the holes.
11. From the bottom of the Shelf, connect the remaining four (4) Keps nuts to the screws, and hand-tighten only.
12. Slide the ProductionVIEW console on for proper fit. Carefully remove the ProductionVIEW console, so as not
to move the angle brackets, and then tighten the screws down.
13. Place the ProductionVIEW console back onto the sliding shelf. Line up
the holes on the sides of the angle brackets with the holes in the
ProductionVIEW console. Use the remaining four (4) 10-32 x .313”
screws to mount the ProductionVIEW to the Mounting Tabs (see picture
to the right).
Example: Two (2) Rack Enclosures Bolted Together.
Rack screws not provided