Vaddio WallVIEW CCU 300 User Manual
Page 2
WallVIEW CCU 300
WallVIEW CCU 300 Installation and User Guide 341-720 Rev. B
Page 2 of 12
UNPACKING
Carefully remove and identify the following parts for the WallVIEW CCU 300 system:
• One (1) - Sony BRC-300 Standard Definition PTZ Camera
• One (1) - Vaddio EZ Interface Module CCU (EZIM CCU)
• One (1) - Vaddio EZIM CCU to SD Break Out Cable
• One (1) - Vaddio Quick-Connect CCU Universal (1-RU Rack Mountable)
• One (1) - Vaddio Thin Profile 300/H700 Wall Mount
• One (1) - Sony IR Remote Control
• One (1) - EZCamera Control Adapter (RJ-45 to DB-9)
• One (1) - 36V PowerRite Power Supply with AC Cord Set
• One (1) - 2-position Phoenix Connector for Tally
• Mounting
Hardware
• Documentation
Vaddio
Manual
Sony BRC-300 Manual
Wiring Diagram Example
Figure 2:
The Quick-Connect CCU System uses a Cat. 5 (all 4-pairs) for power to ensure the motors receive the required
current to operate properly. The Video Cat. 5 cable uses all four pairs for video. The RS-232 Cat. 5 provides
communication to the camera for CCU and PTZ control and G/L (where applicable) to the camera. These Cat. 5 cables can
be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out information. NOTE: A direct RS-232 Cat. 5 cable is
required for each Quick-Connect CCU and camera. Daisy-Chain configurations are not supported.
CAT-5 Cables
up to 500’
SD Break-out
Cable
EZIM CCU
Power
RS-232
SD Video on CAT-5
RS-232
Tally
ProductionVIEW™ FX
Y-C Video to
Switcher
SD Video to
Display
S-Video OUT
RS-232 IN
Composite Video OUT
G/L
POWER
Quick-Connect CCU
BRC-300 Camera, Wall Mount with
EZIM CCU (behind camera)
PreVIEW™ Triple 5.6
+
G