Chapter 3: mount the device, Before you install the p333t-pwr in a rack – Avaya P333T-PWR User Manual
Page 19
Issue 1 September 2005
17
Chapter 3: Mount the Device
You can mount the P333T-PWR in a rack.
The P333T-PWR chassis fits in most standard 19-inch racks. It is 2U (3.5”, 88 mm) high.
Before you Install the P333T-PWR in a Rack
●
Disconnect all cables from the unit before proceeding with the rack installation.
●
When installing the P333T-PWR in a rack, ensure that the equipment is positioned such
that it will not cause the rack to become unstable or tip over.
●
Ensure that the combination of equipment in the rack will not cause an overload or
overcurrent condition on the power strip being used and/or the customer's branch circuit.
●
The P333T-PWR units weigh a maximum of 15 pounds (6.8 kg). Be careful when installing
or removing the P333T-PWR product from the rack.
●
If a power strip is being used in the rack, ensure that it has a reliable earth connection. If
the P333T-PWR equipment will be plugged directly into a wall outlet, ensure that there is a
reliable ground connection at the outlet.
●
Ensure that the internal rack ambient temperature is within the operating specification
limits of the P333T-PWR.
●
Ventilation for the P333T-PWR is from side to side. Ensure that there is adequate space on
each side of the P333T-PWR equipment when installed in the rack to allow sufficient
airflow.
Place the P333T-PWR in the rack as follows:
1. Snap open the hinged ends of the unit’s front panel to reveal the screw holes. Refer to
Figure 2: Closed hinged end
Figure notes:
1. Closed hinged end
P333R
EXPANSION
SLOT
51
59
FDX
15
56
64
53
61
52
60
54
62
FIV
55
63
COL
LNK
58
66
57
65
Tx
Rx
1
13
2
3
14
8
20
5
LAG
17
Hspd
FC
4
16
6
18
7
19
10
22
SYS
9
21
OPR PWR
23
11 12
24
13
14
15
16
17
1
LAG
2
3
4
5
CONSOLE
21
18
19
20
23
22
24
9
6
LAG
7
8
11
10
LAG
12
ROUT
1