Vaddio WallVIEW D80 and D90 - Manual (Page 8)

WallVIEW D80 PTZ and WallVIEW D90 PTZ Manual
© 2012 Vaddio - All Rights Reserved. Document Number 342-0505 Rev A Page 8 of 12
Finishing the Install:
Final Step:
Please check all Cat-5 cables for continuity in advance to final connection. This will save hours of trouble
shooting time.
 Attach the Cat. 5 cable for Power and Video to the Quick-Connect Box. Use the supplied Video cables
and plug these cables from the Quick-Connect Box to the video destination (codec, monitor, projector,
switcher/mixer etc…).
 Connect the PowerRite power supply to the Quick-Connect Box power input.
 Verify all connections.
 Connect only the Vaddio supplied power supply to an AC outlet. Power will travel down the Cat-5 cable
to the shoe, which regulates and supplies 12 VDC to the camera. The camera will “Home” to a centered
position ready for control information from the provided Vaddio IR Remote Commander or RS-232
camera controller of the integrators’ choice.
Documents and Information
For documents on video, power and control pin-outs, please see the Vaddio website under Tech Center, General
Technical Notes, WallVIEW Video, Power and Control Pin-Outs Technical or the Appendix at the back of this
manual.
For RS-232 control information, please see the full-length manuals for each of the manufacturer’s camera models
(Sony EVI-D80 or Sony EVI-D90) either on the Sony website or the Vaddio website
www.vaddio.com .
Vaddio has prepared a number of Tech Notes, specifications and drawings designed to inform and educate
integrators’ of the value and the specific uses of Vaddio products.
For general specifications on the Sony EVI-D80 and EVI-D90 cameras please see the Sony manuals that are
shipped with each camera.
For compliance testing information, please see Sony manuals for FCC and CE testing results and warnings.