Vaddio WEBBi - Manual (Page 6)

WEBBi - Web Controller
Vaddio WEBBi - Web Controller - Document Number 342-0445 Rev B Page 6 of 24
Equipment Descriptions and Call-outs
Diagram: WEBBi Front Panel
1) Recessed Power/Reset Button: Resets and reboots the WEBBi device with push button activation.
2) LCD
Display: Scrolls current IP Address across the screen when the unit is plugged in.
3) RS-232 LED Indicators: Blue LED indicators for both the Audio & Video port connection to the EasyUSB
Tool devices. LED will flash when communication activity is detected with the device under control.
4) Network LED Indicators: LEDs will flash blue to indicate detection of Ethernet activity between web server
and attached browser client.
5) Power LED Indicator: This LED will illuminate blue when power is detected.
Diagram: WEBBi Rear Panel
1) Power
Connector: 5.5mm OD x 2.5mm ID coaxial connector, positive center for supplying power to device.
Use with 12 VDC, 1.0A power supply included in package only.
2) DIP Switches: Used to reset device to factory defaults. Setting all dip switches to the off-position will reset
the unit to factory defaults on the next power cycle. User will lose all programmed configurations on the
factory default operation.
3) Audio Control: RJ-45 connector with RS-232 functionality (see appendix for pin-out). RS-232 Control port
for use with Vaddio EasyUSB Mixer/Amp. .
4) Video Control: RJ-45 connector with RS-232 functionality (see appendix for pin-out). RS-232 Control port
for use with Vaddio HD-USB PTZ Camera or AutoPresenter.
5) USB: For future use.
6) Network: 10/100 Ethernet port for connection to the Local Area Network.
7) IR
Port: For future use.
➌ ➎ ➍ ➊ ➋
➌ ➎ ➍ ➊ ➋ ➏ ➐