Beijer Electronics iX T7AM EN - Manual (Page 8)

Installation
2.2 Installation Process
The following is needed:
• A Phillips/slot screwdriver
1. Unpack and check the delivery. If damage is found, notify the supplier.
Note:
Place the operator panel on a stable surface during installation.
Dropping the panel or letting it fall may cause damage.
2. Use the cut out dimensions that are included on the outline drawing, found
in section Operator Panel Drawings and in the Technical Data table, to cut
a correct opening in the cabinet. A separate cut out drawing is available for
download from the Beijer Electronics web site.
3. Secure the operator panel in position using all the fastening holes and the
provided brackets and screws:
x 4 0.5 - 1.0 Nm
Beijer Electronics, MAEN118A 8