Beijer Electronics QTERM®-A12 - Manual (Page 24)

Installing the Terminal Installation
18 QTERM-A12 Terminal
the back panel may indicate the orientation. If not, you can determine which side should
be at the top by the position of the serial port(s) on the back panel as follows:
• Landscape
When looking at the front of the unit, the back panel serial port(s) should be facing down.
• Portrait
When looking at the front of the unit, the back panel serial port(s) should be facing left. Refer to
Figure 4 for an example of a landscape installation.
3. Install nuts and washers onto each of the six mounting studs. Torque all nuts to 67.8 N cm
(6 lbs in) to create a seal between the terminal gasket and the panel. Avoid overtightening
the nuts.
Figure 4
Modular QTERM-A12 Mounting