Beijer Electronics iX Panel K60 EN - Manual (Page 39)

Fault Tracing
The iX Panel K60 is working, but one or more keys are
not working
1. Check that the flex cables are correctly fitted.
2. Replace the front according to the
Replacing the Rear Cover section.
Lines in display has wrong color or the display picture
is shifted
1. Check if the display has a wide vertical or horizontal area across the
display. It should be at least 2-3 cm wide with a grey or black color. See
Replacing the Display/Display Cable for instructions on how to correct this.
2. Make sure the display cable is correctly fitted.
3. Make sure the display cable is not folded or damaged in any way. Replace the
display cable according to the Replacing the Display/Display Cable section.
The iX Panel K60 will not restart after changing a
component
1. Remove and insert the battery again.
Low battery / No battery
1. Check that the battery is correctly fitted in its holder.
2. If low battery/no battery voltage, replace the battery according to the
Replacing the Battery section.
Beijer Electronics, MAEN001 39