Beijer Electronics iX Panel K100 EN - Manual (Page 40)

Fault Tracing
The iX Panel K100 is working, but one or more keys
are not working
1. Check that the flex cables are correctly fitted.
2. Replace the front according to the
Replacing the Rear Cover section.
Lines in display has wrong color or the display picture
is shifted
1. Check if the display has a wide vertical or horizontal area across the
display. It should be at least 2-3 cm wide with a grey or black color. See
Replacing the Display/Display Cable for instructions on how to correct this.
2. Make sure the display cable is correctly fitted.
3. Make sure the display cable is not folded or damaged in any way. Replace the
display cable according to the Replacing the Display/Display Cable section.
Low battery / No battery
1. Connect iX Panel K100 to an external power source to automatically charge
the battery.
Beijer Electronics, MAEN003 40