Decolav 5234 - Manual (Page 2)

LINEN TOWER INSTALLATION
INSTRUCTIONS
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
2
Notes:
o Pictured item may be diff erent than actual item. This document is for instructional purposes only.
o We recommend two people to install this product.
Step # 2
o Slide the Linen Tower toward the wall. Leave enough room behind the wall cabinet to install the zip tie to
connect the two Anti Tip brackets. Figure C
o Connect the two Anti Tip brackets with the Zip tie and leave the Zip Tie a little loose. Figure C
o Slide the linen tower against the wall and level by adjusting the fl oor glides.
o Pull the Zip Tie tight and clip off the excess using scissors or cutting pliers
Figure C
Adjusting the Hinges
o The rear screw will move the door closer to the end panel or
away from the end panel. If the door is rubbing the end panel,
use this adjustment screw. Remember to adjust both hinges on
the door for the desired clearance. Figure D
o To get the doors even across the top and bottom edges of the
doors use the side to side adjustment screw. Remember to
adjust both hinges on the door for the correct position. Figure D
o Doors were adjusted at the factory prior to shipping but due to
the variances in home walls the hinges may need slight
adjustment.
Moving the Hinges to the Opposite Side
o Unclip the Hinge from the Hinge plate using the hinge
release button on the back of the hinge between the
hinge plate and the hinge. Figure E
o Repeat for all hinges on door and lay door to the side.
o Unscrew the two mounting screws on each Hinge Plate
and move the move them to the opposite side.
Figure E
o Repeat for all the hinge plates
Figure D
Figure E
Anti Tip
Bracket
Zip Tie
Side to Side Adjustment
Front to Back Adjustment
Hinge Plate Screws
Hinge Plate
Hinge
Hinge Release
Button