Fagor SF-800 User Manual

Page 11

Advertising
background image

20

EN

21

EN

1 - INSTALLATION

1.1 - G

ENERAL PRESENTATION

(Fig. 1.1)

EN - ENGLISH

Control panel

Filter

Vent hose

A
B

C

Adjustable feets

Information plate

Light

(according to model)

D
E

F

1.7 - V

ENTING THE AIR

The hot air coming from your appliance must be ven-
ted away, either:
— Directly to the room if it is well-ventilated (Fig.
2.4.1).
— Via a permanent connection on the wall. The out-
let nozzle must be situated at a height of 30 cm to
avoid condensation forming in the vent hose. The
slats in the outlet nozzle must be at least 15mm
apart to avoid clogging

(Fig. 2.4.2

).

— Make sure that the room is well-ventilated, to pre-
vent gas from appliances burning other fuels, inclu-
ding open fires, from blowing back into the room.
— The diameter of the passage through the wall must
be at least the same as the vent hose’s external dia-
meter.

— Temporarily by putting the end of the hose out of
an open window

(Fig. 2.4.2

).

B

A

Never duct into a chimney flue or a mechani-
cal ventilation system, or into a system that

extracts fumes emitted by appliances fired by gas
or other combustible substances (risk of drawing
combustion gases).

The vent hose must be installed horizontally or

upwards and must never hang down. It should
contain as few bends as possible (2 at most) (Fig.
2.4.2

).

It must not be increased in length.

Grills with fly screens should not be used.

1.8 - M

ODIFYING THE AIR OUTLET

The following actions must be taken before
connecting your dryer.

You must first of all release the flexible vent

hose.
Your appliances air outlet is on the right (viewed
from the front) but you can alter this. You have three
possible outlets:
— Right-hand side air outlet (Fig. 2.5.1).
— Unclip the handle by pulling it outwards and then
release the vent hose

.

— Rear air outlet (Fig. 2.5.2).
— Release the cover

using cutting pliers.

— Release the duct carefully to avoid any risk of
being cut.

— Left-hand side air outlet (Fig. 2.5.3).
— Remove the left-hand hole cover.
— Pass ht hose and handle assembly through the
panel, orienting the handle

.

— Insert the right-hand hole cover.

C

B

A

C

— Reverse the hinge

and fasten it back on.

B

— Reverse the bolt

and fix it on the door.

C

— Fasten the hinges screws

and

.

B

A

— Screw the screw

the opposite side to the

bolt.
— Reverse and fix the hinge

without tightening

the screws completely.
— Refit the door on the hinge

.

A

A

D

— Reverse the lock

with the hide and lock

.

E

F

During the laboress to disassembly and
reassembly of the door, you must take the

door horizontally.

Important:

Please read this user manual carefully before installing and using your machine so

as to familiarise yourself with its operation and keep this user manual for reference purposes.

This machine, which is intended for domestic use only, has been designed to dry damp clothing and house-
hold fabrics

SAFETY

I

NSTALLATION

— Your electrical installation must be able to take the
maximum power indicated on the identification
plate and the socket must be earthed correctly.
— Your tumble dryer must be kept disconnected
from the mains supply throughout the whole instal-
lation process.
— It is recommended that you unplug the machine
when you are not using it.
— Once your appliance has been installed, the elec-
trical plug must remain accessible.
— If the power cord is damaged, only entrust the
electrical work to a qualified electrician so as to
steer clear of any danger.
— The machine must not be installed behind a self-
locking door a sliding door or a door with the hinges
on the opposite side to the tumble dryer, that pre-
vents the machine from being fully opened.

ENVIRONMENT

E

NERGY SAVINGS

— Spin your textiles at high speeds; the residual
dampness will be low, as will your energy consump-
tion.
— Place the maximum load in your machine; this will
optimize the energy used. When doing so, comply
with the indications on volume provided in this ins-
truction manual.
— Clean the filter after each drying cycle.
— Swich off your tumble dryer at the cycle ends.

C

HILDREN

S SAFETY

— Do not let children play with the appliance and
keep pets away from it.
— Keep the packaging materials out of children’s
reach (e.g.: plastic bags, polystyrene, etc.) because
they can be dangerous for children: risk of suffoca-
tion.
— This appliance can be used by children aged from
8 years and above and persons with reduced physi-
cal,sensory or mental capabilities or lack of expe-
rience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.

Important:

You must observe the following instructions:

— Do not use solvents in the appliance.
— Do not put laundry that has been treated with stain remover, solvent or inflammable products in the machine
immediately after it has been treated (fire or explosion risk).
— Substances contained in soiling such as oil, acetone, alcohol, petrol, kerosene, stain removers, turpentine or
wax must be removed before drying in your machine.
— Strictly comply with the care instructions on your laundry.
— Check regularly the vent hose. If there is some water in the pipe (through condensation) you must empty it.

E

NVIRONMENTAL PROTECTION

The appliance’s packaging material is recyclable.

Help recycle it and protect the environment
by dropping it off in the municipal
receptacles provided for this purpose.
Your appliance also contains a great
amount of recyclable material. It is marked

with this label to indicate that the used appliances
should not be mixed with other waste. The
appliance recycling will be done in compliance with
European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment.
Contact your town hall or your retailer for the used
appliance collection points closest to your home.

1.2 - A

PPLIANCE

S SURROUNDINGS

— Leave a gap of at least 1 cm around the device
when you install it to facilitate air circulation.
— Do not install your device on a mat or a carpeted
floor since this may impede the circulation of air
around its base.
— If you have installed your device in a small, closed
room a door or window should be left open whilst
the machine is running.

1.3 - L

EVELLING

(Fig. 1.2)

Screw in or screw out one or more of the
adjustable feet to ensure that the machine is

horizontal and doesn't rock, depending on how
level your floor is.

1.4 - B

UILT

-

IN INSTALLATION

— If you are fitting the appliance underneath a work-
top, you must keep the original laminated top.
— For safety reasons, the appliance must never be
operated without a top.

1.5 - C

OMBINED WASHER

/

DRYER INSTALLATION

An adaptation kit is available from your dea-
ler. This is used to mount your tumble dryer

above your washing machine.
— Check that the kit is compatible with your wash-
ing machine.
— For safety reasons, fitting must be performed by
a qualified professional.

1.6 - M

ODIFYING THE DOOR OPENING DIREC

-

TION

(Fig. 2.2 - 2.3)

To alter the direction the door opens as follows:
— Remove the 4 screws in the front panel holding
the hinges

and

.

B

A

Advertising