Fagor MG-300 - Manual (Page 9)

8
or plug are damaged or in the event
of a malfunction or improper working.
The user should never attempt to
change the cable. If, for any reason,
the cable requires examining, repairing
or modifying, contact a Technical
Assistance Service authorised by the
manufacturer.
• Do not leave the cable hanging over the
edge of the table or work surface. Do
not let it become tangled or come into
contact with hot surfaces. Check the
cable regularly for any damage.
• Do not leave the appliance on or near
a hot gas burner or electric hob or in or
beside a hot oven or a microwave oven.
• Do not use abrasive detergents or
caustic or oven cleaners to clean the
appliance.
• Before using, make sure there is
enough clear space above and around
the appliance to allow sufficient air
circulation. Do not let the appliance
come into contact with curtains, painted
paper, clothes, kitchen cloths or any
other flammable material during use.
• WARNING: On surfaces where heat may
be a problem, we recommend the use of
a thermal insulating sheet.
• Never leave the appliance unattended
while in use.
• Do not let children or the mentally disabled
use the appliance without supervision.
• Do not leave the appliance open to the
elements (rain, sun, frost, etc.).
• This appliance is not designed for
outdoor use.
• Never use any electrical appliance
when the cable or plug are damaged or
when it is not working properly or has
been damaged in any way. Take it to an
authorised technical assistance centre to
be examined, repaired or modified.
• In the event of technical failure and/or
improper working, switch the machine
off and do not try to repair it. Repairs
should only be carried out by an
authorised Technical Assistance Service.
Always demand the use of original spare
parts and accessories.
• This appliance should not be used
by physically, sensorially or mentally
4. INSTRUCTIONS FOR USE
Before using for the first time, clean the
plates with a soft cloth.
Close the appliance by lowering the upper
lid and then plug into the mains. Turn the
timer control to 10 minutes. The On/Off pilot
light will come on, indicating that the plates
have begun to heat up. When the timer
reaches 0, a buzzer will sound, indicating
that the appliance has been disconnected
and is ready to cook the pizza.
When the buzzer sounds, open the lid using
the handles provided. Take care not to touch
the hot surfaces. Place the pizza on the
lower heater plate.
Close the lid and turn the timer to:
GP-240: 8 minutes
GP-280 / MG-300: 11 minutes
If the pizza you wish to cook is frozen, turn
the timer to:
GP-240: 12 minutes
GP-280 / MG-300: 15 minutes
The above times are set for pizzas whose
thickness is less than the height of the
lower plate and are, in any case, meant as a
guideline only. They may vary according to
personal taste.
When the timer reaches zero, the buzzer will
sound once again, indicating that the pizza
is ready to eat.
Use the handles to open the lid, taking care
not to touch the hot surfaces. To remove the
pizza, do not use metallic utensils as they
may damage the non-stick surface. Always
use wooden or heat-resistance plastic
utensils.
Unplug the appliance and leave to cool
before cleaning.
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.