Fagor CA-80 - Manual (Page 9)

8
4. ASSEMBLY
5. OPERATION
Before operating the fan, place it on a flat,
stable surface.
Place the timer (2) in the off position (“0”)
and plug in the appliance.
• Switch on the appliance by turning the
timer (2) to the on position (“I”).
• Select the desired speed by turning
the speed adjustment selector dial (1)
clockwise. If you want the fan to oscillate,
turn the selector dial anti-clockwise.
“0” = off
“1” = low speed
A. Fit the two parts of the base column (4)
together as shown in Fig. 2. Thread the
cable through the central hole and align
the screw holes on the base column
(4) with those of the fan. Then insert
the screws and tighten them with a
screwdriver (Fig. 3).
B. Fit the two parts of the base (5) together
as shown in Fig. 4. Thread the cable
through the central hole in the base. Align
the screw holes on the base with those
of the fan. Then insert the screws and
tighten them with a screwdriver. (Fig. 5)
C. Position the cable in the groove on the
base (Fig. 6).
• Do not place the fan beneath curtains or
similar.
• Do not introduce any objects into the
grille.
• Do not leave the appliance next to any
focus of heat or on hot surfaces.
• Do not direct the flow of air directly
towards babies or ill persons.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
7. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to a
dealer providing this service.
Disposing of a household appliance separately
avoids possible negative consequences for
the environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to obtain
significant savings in energy and resources.
To remind you that you must collaborate with a
selective collection scheme, the symbol shown
appears on the product warning you not to
dispose of it in traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
6. CLEANING
Before carrying out any cleaning or
maintenance operations, switch off all the
controls and unplug the appliance. Use
a soft, slightly damp cloth to clean the
outside of the fan. Do not allow water into
the engine during cleaning. Do not immerse
the appliance in water. Do not use solvents,
abrasive products, or any other chemical
product to clean the fan.
“2” = medium speed
“3” = high speed
• If you wish to select a period of
operation, set the desired time by
turning the timer control (2) clockwise
to the desired time within a range of
0 to 120 minutes (2 hours). Once the
selected time has passed, the fan will go
off automatically.
• To disconnect the fan, switch all the
controls to Off (speed and timer) and
unplug the appliance.