MIPRO ACT-818 Wideband Single-Channel Digital Receiver - Manual (Page 13)

Indicates the frequencies did not sync successfully. Ensure the IR windows in both the
receiver and transmitter are lined up and can “see” each other, then press the ACT
button again.
To Activate:
Press the “ACT” button once to activate the ACT sync function. Once activated, the
words “ACT” and “Sync” on the receiver will illuminate. Flashing will stop when the IR
signal is received by the handheld or bodypack transmitter or no IR signal is received
within 10 seconds.
To Cancel:
! When the words “ACT” and “Sync” on the receiver illuminate, press the ACT button
again.
! When the words “ACT” and “Sync” on the receiver illuminate, do not press any
button. ACT function will stop and cancel automatically after about 10 seconds.
Instructions:
1. Ensure a receiver channel is set up (Group / Channel), the transmitter battery is
charged and the transmitter is powered ON.
2. Press the ACT button on the receiver to activate the ACT function. Once activated,
the words ACT and Sync will illuminate.
3. Bring the ACT handheld or bodypack transmitter within 30cm (12”) of the IR port on
the receiver (check your transmitter documentation to find out where the IR port is
located on the transmitter). The receiver IR port is located behind the “ACT” button
and indicated by a round dark red dot.
The transmitter/receiver frequency will sync automatically.
4. When the frequencies are successfully synchronised the words ACT and Sync will
disappear and the RF meter will immediately indicate full RF signal received.
NOTE: If encryption is turned on, the ACT function will also send a new encryption key
to the transmitter and lock it. To unlock the transmitter it is necessary to
re-sync the transmitter again using ACT with the receiver in “Encryption OFF”
mode.
20 21
Setting ACT Transmitter Frequency
Press ACT button ACT indicator illuminates
Wideband Digital Receivers Wideband Digital Receivers
BA: Transmitter Battery Meter (receiver display)
The battery meter illuminates when the transmitter is powered ON. The LCD battery
meter gives a percentage (%) indication of remaining battery life, as shown above.
Recharge the transmitter battery (or replace with a charged battery pack) immediately
when battery indicators fall to 10% (1 bar showing as indicated above).
BA BA BA BA BA BA
MHz
L
ACT
RF AF SQ
ANT
ADD EQ CH GRP BA BA