頁面 10 – MIPRO ACT-71 Wideband Single-Channel True Diversity Receiver User Manual

Page 10

Advertising
background image

CHANNEL setting

SET

SELECT

FREQUENCY setting

CH Cursor

Instructions:

1. Groups 16 contains 2,881 user-defined frequencies. Up to 16 frequencies can be

selected and stored.

2. Press and release the button once. The cursor starts flashing to

denote it is ready to accept parameter changes.

3. Turn Rotary Controller left or right and stop at . Press and release the Rotary

Controller once and the current number starts flashing.

4. Turn Rotary Controller left or right to increase or decrease numbers in

increments of 1MHz (first 3 digits of the frequency #).

5. Press and release the Rotary Controller again to confirm the first 3 digits, then turn

left or right to adjust the last 3 digits of the number in increments of 25 KHz.

6. Press and release the Rotary Controller once more to confirm the change. The

number stops flashing.

7. To confirm and save the new parameter, press and release the button once.

The cursor stops flashing and the new number is now stored into
memory. If the new frequency is not one of the preset channels for that Group, the
display will show asterisks in place of the Group and Channel designations.

True Diversity Receivers

True Diversity Receivers

14

15

Turn knob clockwise to auto scan
from beginning to the end of frequency band

Turn knob counterclockwise to auto scan
from end to the beginning of frequency band

1. Press and release the button once. The cursor starts flashing to

denote it is ready to accept parameter changes.

2. Turn Rotary Controller left or right and stop at . Press and release the Rotary

Controller once and current number starts flashing.

3. Turn Rotary Controller left or right to increase or decrease numbers. If there

is interference on your chosen CH, it will automatically jump to the next interference-
free CH.

4. Press and release the Rotary Controller once to confirm the change. The

number stops flashing.

5. To confirm and save the new parameter, press and release the button once.

The cursor stops flashing and the new number is now stored into
memory.

4

4

4

4

SET

SELECT

FRQ Cursor

Turn knob clockwise to increase frequency

Turn knob counterclockwise to decrease frequency

Instructions:

4

4

4

4

4

NOTE: If a new frequency is selected that is not among the preset channels for the
chosen Group, it MAY not be compatible with the other channels within that Group and
may potentially cause interference. If this occurs, the frequency will need to be
changed to avoid problems. The preset channels within each Group are specifically
selected to work together when using multiple systems simultaneously.

4

4

CH

CH

CH

CH

CH

CH

FRQ

FRQ

FRQ

FRQ

FRQ

FRQ

FRQ

Advertising