MIPRO ACT-717 Single-Channel True Diversity Receiver - Manual (Page 11)

SET
SELECT
NAME Cursor
Turn knob clockwise to increase letters, values, and symbols
Turn knob counterclockwise to decrease letters, values, and symbols
SET
SELECT
ADD Cursor
Turn knob clockwise to increase values
Turn knob counterclockwise to decrease values
Instructions:
4 4
NAME setting NAME
Instructions:
1. Press and release the button once. The cursor starts flashing to
denote it is ready to accept parameter changes.
2. Turn Rotary Controller left or right and stop at . Press and release the
Rotary Controller once and the current alphanumeric characters start
flashing.
3. Turn Rotary Controller left or right for alphanumeric characters like numbers,
letters and signs.
4. A total of 6 alphanumeric characters can be changed.
5. Turn and press the Rotary Controller once to confirm each character change.
Once all 6 characters are changed, the character stops flashing.
6. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new NAME is now stored into memory.
4
4
4
4
NAME
NAME
ADDRESS setting ADD
1. Press and release the button once. The cursor starts flashing to
denote it is ready to accept parameter changes.
2. Up to 64 receiver channels can be remotely monitored and controlled by MIPRO
proprietary software and hardware via its ACT-BUS computer interface.
3. Address numbers need to be pre-programmed in advance from “01 ~ 64” before
interfacing for network monitoring and control. However, to ensure networking is
working properly, all address numbers need to be different from each other to avoid
address conflicts. (Note: The same address number can be repeated for different
receiver channels IF a computer is not being used to control / monitor the systems.)
4. Turn Rotary Controller left or right and stop at . Press and release the
Rotary Controller once and the current number starts flashing.
5. Turn Rotary Controller left or right to increase or decrease numbers.
6. Press and release the Rotary Controller once to confirm the change.
The number stops flashing.
7. To confirm and save the new parameter, press and release the button once.
The cursor stops flashing and the new address is now stored into memory.
4
4
4
4
ADD
ADD
ADD
ADD
True Diversity Receivers True Diversity Receivers
16 17