MIPRO ACT-101 IR Remote-Controlled Single-Channel Diversity Receiver - Manual (Page 5)

+ -
ANT.B
4
PART NAMES AND FUNCTIONS
0dB +10dB -6dB CE
SQ LEVEL
8 9 10 11 12 7
7
8
9
10
11
12
(Figure 2)
Rear Panel
Wireless IR Remote Control Receiver
DC Input Jack: For 12V DC power input connection. Connects center pole to positive
voltage.
Antenna B Input Connector: To install the antenna B.
Unbalanced Output Socket: Unbalanced 1/4” phone jack audio output. Three level
switches:〝-6dB〞、〝0dB〞、〝+10dB〞.
Unbalanced Level Switch: At〝0dB〞level output equals to cabled microphone. At
〝+10dB〞level, it is AUX volume output. At 〝-6dB〞 level, the volume output is half
of cabled microphone.
SQ: Squelch adjustment. Adjusts receiver sensitivity to mute audio output from the
speaker when no microphone signals are present.
Antenna A Input Connector: To install the antenna A.
ANT.A
5
ACT-101 External ACT Port Receiver
PART NAMES AND FUNCTIONS
Wall Mount :
Front Panel
ACT-101
ACT POWER EXTEND
13 14 15
(Figure 3)
POWER Indicator: Indicates power status. An illuminated indicator denotes receiver
has received IR signal and now turned on.
ACT Port: Receive signal to turn on (and off) receiver and sync frequency to
transmitter.
EXTEND Socket: Connect enclosed RJ-11 network cable to same EXTEND
location of the main ACT-101 receiver.
NOTE: The purpose of installing an ACT-101 External ACT Port Receiver is to improve
infrared transmitting & reception signal quality for powering on & off the receiver as
its path maybe shielded or blocked. For example, if the main receiver is installed
inside an enclosed rack case, room or similar environments. It can be wall mounted
or stand alone.
13
14
15 5